Analysis of the real difference between national standard cable and non standard cable


release time:

2020-01-09

Cable practitioners are familiar with a sensitive topic in recent years: it is too difficult to sell national standard, saying that their cables are national standard, non-standard also say that they are national standard

Cable practitioners are familiar with a sensitive topic in recent years: it is too difficult to sell national standard, saying that their cables are national standard, non-standard also say that they are national standard, and the result is the best in quotation, which once made the cable market practitioners very helpless;

Where is the real difference between national standard cable and non-standard cable, we can learn from the following points:
1. calculate the cost by weight of copper. At first, it worked, but the national standard ignored a problem. Your copper is oxygen free rod, but not standard one. When the weight of waste copper and oxygen free rod is the same, the price of waste copper and oxygen free rod is 10%. So the national standard cable took great efforts to publicize, failed, the difference between the national standard and the non-standard guarantee bottom was 10%.
2. the auxiliary materials are cut off. The state has increased resistance inspection, and also increased the inspection of conventional products. Non-standard cables began to work on auxiliary materials. If copper accounts for 70% of the cost of cables, the cost of auxiliary materials takes up about 20%, which is 20% of the cost. If the materials are used a little bit, the price is 5% different from that of national standard. We also see that many of the cables exposed recently have problems with accessories.
3. the wire is short to the cable is short. In fact, the short meter has always existed, this is the most difficult to check. It used to be common on BV, such as 95 meters, 98 meters, or 90 meters. Now, because of the increase of inspection items, all the products inspected have been included, so non-standard ones have begun to work in this direction again. I hope you can draw attention, 100 meters reduced by 1 meter, 1% of the profit came out.
4. the two sides are thick and medium and thin. That is to say, both ends of the cable are national standard, the middle part is non-standard, so it saves a lot of costs, the corresponding cable price will be much lower. You can't cut the cable from the middle, so the leak is just drilled.
At present, the fourth one is the most worried. As long as the user and cable manufacturer conceal together, it can not be checked at all. Do you want to dig the cable out of the ground and measure it? This is why the price is so different, which is also called "national standard".

cable